The Royal 2200 alarmed panic bar is designed to allow emergency egress when needed and also provides audible monitoring when the door is exited.

The panic bar is equipped with a monitoring mechanism controlled by key switch cylinder. When the key switch is turned to the on position, the panic bar will sound an alarm when used.

The alarm will remain in an audible mode for either two minutes or until the key is used to reset the alarm. This device can also be set to stay on continuously and will not shut off until reset with key.

The 2200 panic bar alarm can be installed to be operated with outside trim.

Available in 36 and 48 inch lengths

Standard grade

Aluminum finish.

*FREE Ground shipping lower 48 US States ONLY!  Details  Stock photos, actual item may vary

• Alarm units have an internal horn. When the push rail is depressed, the horn sounds to provide an audible means of signaling that the door has been opened and violated.
• The unit has changeable 2 minute alarm cutoff or manual reset. Preset at factory for 2 minute alarm cut off. Jumper cable is provided to switch to continuous alarm.
• The key switch to turn the alarm off is a standard 1-1/4" cylinder with "C" keyway. The alarm operates on one standard 9 volt transistor battery. When battery is weak the horn will emit an intermittent signal.
• Alarmed units are supplied with two switches. One switch monitors the push rail and the other switch monitors the latch bolt for full proof security.
• Unit includes "emergency exit only. Alarm will sound" decal for application on door or unit.